I am an undergraduate researcher at the Multifunctional Polymers and Composites lab, this is Colorado State University's material science lab. This lab has many initiatives but I am apart of the Additive Manufacturing group. While working on a research project I also was enrolled in an advanced writing course, Writing in a Digital Environment. The following page has a handful of class assignments which relate to the work I was doing in my research group at the time.

​

Research Project Descriptions

While enrolled in this writing course I had been tasked with two separate research related projects:

1. Develop a high torque, high volume syringe pump

2. Develop a pump system which had the ability to heat up or cool down the material within it

​

What You Will Find Below

The sections below primarily highlight the research that went into the second project (temperature controlled pump system), however, as my research developed outside of this writing course the two projects combined into one. That is, a high torque, high volume syringe pump which has a temperature controlled sleeve that can liquify the materials within it.

​